24 Mar
2006
24 Mar
'06
6:52 a.m.
Alain Knaff wrote:
> Yves Glodt wrote:
>> Hi,
>>
>> I have a strange problem... I have a box running ubuntu dapper, and
>> all is fine.
>>
>> Now I cloned the disk, and put it into another box which is 100& the
>> same hardware, and it still works fine, apart of one thing...
>>
>> What was eth0 and eth1 before is now eth2 and eth3 :-/
I'm having a similar problem with Dapper. My problem is with a laptop.
If I power up with the power cable plugged in and the 100MBPS ethernet
card unplugged, my wireless card shows up as eth1. However, if I powerup
on battery or have my wired ethernet card connected, my wireless comes up
on eth2.
I have one of the lovely Broadcom cards (Dell 1350 miniPCI) and Dapper
uses the new BCM43xx module. I do not have this problem if I use
ndiswrapper.
Any thoughts?
Mike