Hello,

I had a connection problem with router (Zyxel prestige 650H) after to be connected under windows, for an unknown reason configuration parameters were modified and then I have to reinitialize the hardware and reconfigurate it (with ancien parameters such as key for wep, etc) but after, while connection works normally under windows, this works not at all under linux!!I have a laptop which run under mandriva2007, wireless liaison is assumed with ndiswrapper and list of interfaces gives:

ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:C0:9F:B7:BC:13
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interruption:233

eth1 Link encap:Ethernet HWaddr 00:14:A4:3C:E2:52
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interruption:169 Mémoire:c0304000-c0306000

lo Link encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
adr inet6: ::1/128 Scope:Hôte
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:66 errors:0 dropped:0 overruns:0 frame:0
TX packets:66 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:5116 (4.9 KiB) TX bytes:5116 (4.9 KiB)

sit0 Link encap:IPv6-dans-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

network card is Broadcom BCM4318 AirForceOne 54g, but when I doing ifup eth1 (interface used for wireless access) I have as answer: "no link found; check cable?"; I have similar problem with another laptop running under suse10: no mean to obtain an normal IP adress and then any link for the access.
Any suggestion?

Thank you in advance